Removing the bezel assembly

Use this information to remove the bezel assemble from the blade server.

The following illustration shows how to remove a bezel assembly from a blade server.

Note:

1. The illustrations in this document might differ slightly from your hardware.

To remove the bezel assembly, complete the following steps.

1. Before you begin, read Safety and Installation guidelines..
2. If the blade server is installed in a BladeCenter® unit, remove it (see Removing the blade server from the BladeCenter unit for instructions).
3. Open the blade server cover (see Removing the blade server cover for instructions).
4. If an optional expansion unit is installed, remove it (see Removing an optional expansion unit).
5. Press the bezel-assembly release on each side of the blade server and pull the bezel assembly away from the blade server approximately 1.2 cm (0.5 inch).
6. Disconnect the control panel cable from the control-panel connector.
7. Pull the bezel assembly away from the blade server.
8. If you are instructed to return the bezel assembly, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.