After updating the system firmware and successfully starting
up the blade server from the TEMP image, copy the TEMP image to the
PERM image using the diagnostics program commit function.
Note: If you install the server firmware update permanently
by committing the temporary firmware level from the temporary side
to the permanent side, the temporary and permanent sides contain the
same level of firmware. You cannot return to the level that was previously
on the permanent side.
- Load the diagnostics program. See Running the diagnostics program.
- From the Function Selection menu, select Task Selection and
press Enter.
- From the Tasks Selection List menu, select Update and
Manage System Flash and press Enter.
- From the Update and Manage System Flash menu, select Commit
the Temporary Image and press Enter.
- When the commit function is complete, press F3 until
the Diagnostic Operating Instructions screen is displayed; then press F3 again
to exit the diagnostic program.