Installing a serial pass-thru module

You can install a serial pass-thru module while the BladeCenter S system is powered on. To install it in the serial pass-thru module bay, open the release handle and slide the serial pass-thru module into the serial pass-thru module module bay.

Graphic illustrating the installation of a serial pass-thru module into the BladeCenter S chassis

  1. Open the release handle (rotate the handle down).
  2. Slide the module into the serial pass-thru module bay until it stops.
  3. Close the release handle (rotate the handle up).
  4. Connect all cables to the module.