Installing an air damper

The installation of an air damper should only be performed by a trained service technician.

Read Safety and Installation guidelines before performing this procedure.

There is an air damper inside each of the BladeCenter S chassis blade server bays. Perform these steps to install the air damper.

  1. Make sure all blade servers are removed from the BladeCenter S chassis, and that it is disconnected from power.
  2. From the rear of the BladeCenter S chassis, slide the air damper into the air damper slot towards the front of the chassis.
    Graphic illustrating the positioning of the air damper in the chassis slot.
  3. Attach the air damper to the BladeCenter S chassis.
  4. From the front of the BladeCenter S chassis, connect the spring to the air damper, orienting the spring so that it fits into the spring hole.
    Graphic illustrating the spring on an air damper.
  5. Connect the other end of the spring to the BladeCenter S chassis, orienting the spring so that it fits into the spring hole.
  6. Install blade servers (see Installing a blade server).
  7. Connect the BladeCenter S chassis to power.
Parent topic: Removing and replacing FRUs