This topic lists error messages for the dns command.
See Common errors for a list of error messages that apply to all commands.
| Error message | Definition |
|---|---|
| -on and -off cannot both be used in the same command. | A user tries to enable and disable DNS in the same command. |
| At least one address is required to enable DNS. | A user tries to enable DNS without configuring at least one address. |
| DNS State Can not be determined. | An error occurs while the management module is reading the DNS state. |
| Input length is greater than the maximum characters allowed. | A user tries to enter too many characters in an input field. |
| Invalid ip address | A user tries to set an invalid IP address. |
| IPv6 configuration changes will not take effect until IPv6 is enabled. | A user attempts to configure the IPv6 DNS settings while IPv6 is disabled. |
| Reading status of DNS failed. | An error occurs while the management module is reading the DNS state. |
| Reading status of interface failed. | An error occurs while the management module is reading the status of an interface. |