By function, the commands are as follows:
Use these commands to perform top-level functions within the command-line interface:
Use these commands to monitor and control operation of BladeCenter components:
Use these commands to view and configure network settings, Ethernet interfaces, and other functions:
Use these commands to locate other resources on the network:
Use these commands to view and clear primary management-module event log entries:
Use these commands to monitor and control operation of BladeCenter unit LEDs:
Use these commands to reset the management-module configuration and perform firmware updates:
Use these commands to control operation of the BladeCenter unit, blade servers, and I/O (switch) modules:
Use these commands to monitor power consumption of the BladeCenter unit and installed components:
Use these commands to save and restore the management-module configuration:
Use these commands to start an SOL connection to the command console of a specific blade server or to end a command console session:
Use these commands to manage alarms for monitored parameters of the BladeCenter T unit: