led command errors

This topic lists errors for the led command.

See Common errors for a list of error messages that apply to all commands.

Table 1. led command errors
Error message Definition
-d can only be used with the -loc on. A user tries to issue a command to set the -d while the -loc setting is off.
Delay value must be less than max.

where max is 60.

User input for the option -d exceeds the maximum.
Error getting LED status. An error occurs while the management module is getting the system LED status.
Error reading system LED state. An error occurs while the management module is reading the system LED state.
Error setting system LED. An error occurs while the management module is configuring the system LED.
Invalid option argument for -loc. A user tries to enter an invalid argument for the option -loc.
Error setting -loc for blade[slot] An error occurs while setting location LED for the targeted blade.
-l can only be used by itself. User issues a command with -l option inclusive of an argument or other options.
Error turning off information LED An error occurs while the user is setting information LED to off.
The chassis location LED cannot be turned off at this time because one or more blades have their location LED active. A user issues a command to turn off the chassis location LED under conditions when this is not allowed.