This topic lists error messages for the reset command.
See Common errors for a list of error messages that apply to all commands.
| Error message | Definition |
|---|---|
| An error occurred while disabling failover. | An error occurs while the management module is disabling failover. |
| An error occurred while enabling failover. | An error occurs while the management module is enabling failover. |
| Firmware update is in progress. Try again later. | The user tries to reset the management module during a firmware update. The error message displays and the management module does not reset. |
| Rebooting blade failed. | An error occurs while the management module is rebooting the blade server. |
| Resetting and running standard/extended/full diagnostics for I/O module failed. | An error occurs while the management module is resetting and running diagnostics for the I/O module. |
| Resetting I/O module failed. | An error occurs while the management module is resetting the I/O module. |
| There is no backup management module installed. | A user tries to enable failover on a management-module reset and there is no standby management module. |
| Resetting blade blade_number with
NMI not supported. where the blade_number identifies the blade server. |
A user tries to reset a blade server that does not support non-maskable interrupts (NMI). |
| Resetting blade blade_number with NMI
failed. where the blade_number identifies the blade server. |
An error occurs while the management module is resetting a blade server with NMI. |