0x4300010D


         Explanation
                  
            The specified user requested requested that the blade servers in a scalable blade complex operate in stand-alone mode.

         
         
            Severity
         Informational
         
            Alert Category         Blades (Informational)
 -
mmTrapBladeS
         
            Log Source
         Audit
         
            Automatically notify service
         No
         
            Recoverable
         No
         
            Example Message
         Complex A01C (blades 4,5,6,7): Request to set Partition 1 (blades 4,5) to Stand-alone Mode by USERID at 10.10.10.50 (Web)
         User response
                  
            This event only reports a requested action from a user for auditing purposes.
If the blade servers are not operating in stand-alone mode, perform
these steps:

            
               Ensure that all the blade servers in the scalable blade complex are powered off.
               Check the event log for other events related to the specified blade servers and resolve those events.
               Reset the blade system management processor on all blade servers in the scalable blade complex. You
can reset the service processor through the advanced management module Web interface from the
Blade Power/Restart page.
               Reseat the scalable blade complex.
               Update the firmware for the service processor on the blade server.  You can
find the appropriate firmware on the IBM BladeCenter software and device drivers Web page.