Replacing casters

The Office Enablement Kit comes with swivel casters installed on the front and fixed casters installed on the rear of the Office Enablement Kit. Make sure that you install the same type of caster that you removed from the Office Enablement Kit.

Complete the following steps to replace casters on the Office Enablement Kit:

Figure 1. Replacing casters

1. Turn off any installed devices in the Office Enablement Kit according to the documentation that comes with those devices; then, disconnect the cables from those devices and remove them from the Office Enablement Kit.
2. Carefully turn the empty Office Enablement Kit onto the side.
3. To remove an old caster, remove the four screws that secure the caster in place; then, discard the old parts.
4. Install a new caster using the screws that come with the new caster.
5. Repeat step 3 and step 4 for all casters that you need to replace.
6. Carefully turn the empty Office Enablement Kit upright; then, install and connect all of the devices that you removed previously.