Replacing the stabilizer bracket assembly

Complete the following steps to replace the stabilizer bracket assembly on the Office Enablement Kit:

1. Turn off any installed devices in the rack cabinet according to the documentation that comes with those devices; then, disconnect the cables from those devices and remove them from the Office Enablement Kit.
2. Remove the four screws that secure the old stabilizer bracket to the front of the Office Enablement Kit; then, discard the old parts.
   Figure 1. Removing the stabilizer bracket

   
3. Carefully turn the empty rack cabinet onto the side.
4. Remove both front casters from the rack cabinet according to Replacing casters.
5. Pull the old stabilizer bracket extensions from the front of the rack cabinet until they are completely removed from the rack cabinet; then, discard the old parts.
   Figure 2. Removing the stabilizer bracket extensions

   
6. Carefully slide the new stabilizer bracket extensions until they are fully inside the Office Enablement Kit..
7. Install the two front casters that you removed earlier.
8. Carefully turn the empty upright; then, install the new stabilizer bracket to the front of the using the four screws that come with the new bracket.
9. Install and connect all of the devices that you removed previously.