Removing the Office Enablement Kit from the pallet

Use the ramp to remove the Office Enablement Kit from the pallet.

Graphic illustrating the removal of the Office Enablement Kit from the pallet

Complete the following steps to remove the Office Enablement Kit from the pallet.

  1. Place the ramp  1  on the front or rear of the pallet.
  2. Loosen the caster locking screw  2  on each of the four casters so that you can roll the Office Enablement Kit on its casters.
  3. Remove the bolts  3  that secure the Office Enablement Kit to the pallet.
  4. Remove the bolts  4  that hold the front and rear retaining board in place.
  5. Secure the ramp to the pallet using two of the bolts  5  that you removed from the Office Enablement Kit in step 4.
    Attention: Do not roll the Office Enablement Kit off the side of the pallet that does not have a ramp installed.
    Graphic showing exclamation point.
    Graphic showing exclamation point.
    Graphic showing that you should only attempt to roll the Office Enablement Kit off the pallet with a ramp.
    Graphic emphasizing that you should not attempt to roll the Office Enablement Kit off of the pallet without a ramp.
  6. With one person on each side of the Office Enablement Kit, carefully roll it toward the front of the pallet; then, carefully roll the Office Enablement Kit down the ramp until the rear casters are on the floor.
  7. You can now move the Office Enablement Kit to the installation site.
Parent topic: Setting up the Office Enablement Kit