Use these guidelines before you install the blade server or optional
devices.
Before you install optional devices, read the following information:
- Before you begin, read Safety and Installation guidelines. This information
will help you work safely.
- When you install your new blade server, take the opportunity to download
and apply the most recent firmware updates. This step will help to ensure
that any known issues are addressed and that your blade server is ready to
function at maximum levels of performance.
To download firmware updates
for your blade server, complete the following steps.
Note: Changes are made
periodically to the IBM® Web site. The actual procedure might vary slightly
from what is described in this document.
- Go to http://www.ibm.com/systems/support/.
- Under Product support, click BladeCenter®.
- Under Popular links, click Software and device drivers.
- Click BladeCenter HS12 to
display the matrix of downloadable files for the blade server.
- Observe good housekeeping in the area where you are working. Place removed
covers and other parts in a safe place.
- Back up all important data before you make changes to disk drives.
- Before you remove a blade server from the BladeCenter unit, you must shut
down the operating system and turn off the blade server. You do not have to
shut down the BladeCenter unit
itself.
- Blue on a component indicates touch points, where you can grip the component
to remove it from or install it in the blade server, open or close a latch,
and so on.
- Orange on a component or an orange label on or near a component indicates
that the component can be hot-swapped, which means that if the server and
operating system support hot-swap capability, you can remove or install the
component while the server is running. (Orange can also indicate touch points
on hot-swap components.) See the instructions for removing or installing a
specific hot-swap component for any additional procedures that you might have
to perform before you remove or install the component.
- For a list of supported optional devices for the blade server, see http://www.ibm.com/servers/eserver/serverproven/compat/us/.