Installing the bezel assembly

Use this information to install a bezel assembly in the blade server.

Note:

1. The following illustration shows how to install a bezel assembly in a blade server.
2. The illustrations in this document might differ slightly from your hardware.

To install the bezel assembly, complete the following steps.

1. Orient the bezel with the front of the blade server.
2. If the control-panel cable is not already installed, connect the control-panel cable to the control-panel connector on the blade server.
   Note: Some hardware installation and removal procedures that refer to this installation process do not require the control-panel cable to be installed. For example, the DIMM connectors can be accessed without removing and reinstalling the control-panel cable.
3. Carefully slide the bezel assembly onto the blade server until it clicks into place.
4. Install the optional expansion unit, if you removed one from the blade server (see Installing an optional expansion unit for instructions).
5. Install the cover onto the blade server (see Closing the blade server cover).
6. Install the blade server into the BladeCenter unit (see Installing the blade server in a BladeCenter unit).