reset command errors

This topic lists error messages for the reset command.

See Common errors for a list of error messages that apply to all commands.

Table 1. reset command errors
Error message Definition
An error occurred while disabling failover. An error occurs while the management module is disabling failover.
An error occurred while enabling failover. An error occurs while the management module is enabling failover.
Firmware update is in progress. Try again later. The user tries to reset the management module during a firmware update. The error message displays and the management module does not reset.
Rebooting blade failed. An error occurs while the management module is rebooting the blade server.
Resetting and running standard/extended/full diagnostics for I/O module failed. An error occurs while the management module is resetting and running diagnostics for the I/O module.
Resetting I/O module failed. An error occurs while the management module is resetting the I/O module.
There is no backup management module installed. A user tries to enable failover on a management-module reset and there is no standby management module.
Resetting blade blade_number with NMI not supported.

where the blade_number identifies the blade server.

A user tries to reset a blade server that does not support non-maskable interrupts (NMI).
Resetting blade blade_number with NMI failed.

where the blade_number identifies the blade server.

An error occurs while the management module is resetting a blade server with NMI.