telnetcfg (Telnet configuration) command

This command displays and configures the command-line session parameters of the primary management module.

Table 1. telnetcfg (Telnet configuration) command
Function	What it does	Command	Valid targets
Display command-line session configuration	Displays the command-line session configuration of the primary management module.	`telnetcfg`	`-T system:mm[x]` where x is the primary management-module bay number.
Set command-line session timeout for primary management module	Sets the command-line session timeout value for the primary management module.	`telnetcfg -t` timeout where timeout is from 0 seconds (no timeout) to 4294967295 seconds, inclusive. If you enter a value outside this range, an error will be displayed. Command use restricted (see Commands and user authority).	`-T system:mm[x]` where x is the primary management-module bay number.

Example: To set the command-line session timeout for the primary management module to 6 minutes, while management module 1 is set as the persistent command environment, at the system:mm[1]> prompt, type

                  telnetcfg -t 360

To display the command-line session configuration for the primary management module, while management module 1 is set as the persistent command environment, at the system:mm[1]> prompt, type

                  telnetcfg

The following example shows the information that is returned from these two commands:

               system:mm[1]> telnetcfg -t 360
OK
system:mm[1]> telnetcfg
-t 360
system:mm[1]>