uplink command errors

This topic lists error messages for the uplink command.

See Common errors for a list of error messages that apply to all commands.

Table 1. uplink command errors
Error message Definition
-ip must be a valid IP address before enabling -el The user tries to issue a command to enable the -el without a valid -ip setting.
Getting status of failver on Lose/Logical of Physical Link failed. An error occurs while the management module is reading status of failver on Lose/Logical of Physical Link.
Invalid uplink delay value. A user tries to enter a delay value that is less than 1 or greater than 255. For example, uplink -del 0.
The option argument for option is out of the valid range (between 1 and 2880 minutes).

where option is the number of minutes specified.

The user input for an option is out of the range.
The option argument for option is out of the valid range (between 10 and 172800 seconds).

where option is the number of seconds specified.

The user input for an option is out of the range.